How to solve the use accident of car tail plate

Subsequently in our country social economy unceasing, the rapid, the physical and mental health development trend, the freight volume doubled growth, each kind of highway capital construction speed accelerated, the highway freight transportation continued to grow, to the high efficiency transportation tool request gradually enhances. Both of these have clearly set higher rules for the tailboard of the car.

At present, the installation of car tail plate is an efficient way to deal with freight logistics. After installing the tailstock, only the loading, unloading, and handling of goods must be carried out by oneself. Work efficiency is further improved, labor efficiency is small, can make full use of the economic benefits of the car. A lot of drivers use the tailgate. Because of the working environment, most of them have not been exposed to specific technical guidance on the application of car tail plates, and do not know how to prevent and deal with car tail plate safety accidents.

Damage to mechanical equipment:

In the process of hydraulic lifting, the tail plate of the car has the risk of squeezing the top of the head or limbs of the staff.

Preventive measures:

1. The operation handle of tailboard themed activities installed in the trunk can only function as a lift for the tailboard.

2. The up and down operation of the tail plate is only carried out at the outside rear side of the vehicle where the operating box is fixed.

3. No one shall enter the work area while the tail plate is working. Safety warning spacing.

Collision damage of objects:

In the actual operation of the car tail plate, the manual hydraulic forklift transporting goods is not locked, fixed or overloaded, resulting in the imbalance of the service platform. The hydraulic forklift skidded off the tail plate with the cargo, knocking down and damaging the workers standing on the side of the tail plate.

Preventive measures:

1. Place goods strictly in accordance with the rated load limit and car tail plate, especially when unloading, to avoid excess weight.

2. When loading and unloading cargo entering and leaving the trunk, personnel must keep the cargo in the middle according to the stern plate. It is not easy to dump the goods onto the front plate because of the uneven force on the back plate caused by the weight of goods on one side of the back plate.

3. The tail plate shall not rise and fall too fast. Do not adjust the Angle of tail plate when loading.

Fall injury:

During the lifting and lifting of the tail plate, when the stevedores are lifting and lifting together with the hydraulic forklift or cargo, do not stand on the edge of the tail plate. There is a risk that the stevedores on the edge will miss or fall, and the stevedores and cargo may fall together.

Preventive measures:

Do not allow operators to stand in front of the moving goods. Be very careful standing on either side of the big board. It is hoped that the above car tail plate accident handling knowledge can be helpful to many drivers. Each tail plate product is attached with the instruction manual that strictly follows the national tail plate standard. Users should carefully look up and strictly abide by it before using it!